Monroe 288 User Manual download pdf (Page 5)

- 5 -

The Main screen:

Figure 6.

CPM Operation ___

Permits changing the current setup, getting the last manual or auto sequence test result, and setting the clock

in the 288B.

If the 288B is enabled with the optional graphing software key, this screen will also:

Start a decay or balance test via serial / LAN communication.

Graph test results and log data into a file.

NOTE: The graphing software will only graph those tests run by the pc. Tests performed by a stand-

alone 288B cannot be graphed.

Transfer Test Results from CPM ___

This will transfer all the test results in the 288B back to your computer, and log them into an excel file.

NOTE: The graphing software will only graph those tests run by the pc. Tests performed by a stand-

alone 288B cannot be graphed.

Name Locations ___

Permits entering Group and location names, then transferring the names to the 288B to log the test result. Refer

to Name Locations section later in the manual.

If the 288B is connected, the firmware

version and S/N will be shown in here.

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Monroe 288 User Manual Page 5