For use on Monroe Pro
Changing the Ribbon Cartridge
Use the Monroe P51M Ribbon
1. Remove excess paper tape.
2. Remove the printer cover. (Note how
ribbon feeds, around guides and between
print wheels and platen; black band up).
3. Lift out cartridge by moving the lever to
the center; then move and lift out
cartridge.
4. Holding new cartridge over spindles with
black band up and exposed portion of
ribbon on side nearest print wheels, place
cartridge on spindle and engage
cartridge…
5. Replace printer cover.
For Use on Monroe Pro
Changing the Ribbon
Use the Monroe P65M Ribbon
1. Remove excess paper tape.
2. Remove the printer cover. (Note how
ribbon feeds from outside of spools,
around guides and between print wheels
and platen, black band up.)
3. Lift out spool that is not engaged by lever; then
move lever aside and lift out other spool.
4. Holding new spools over spindles with black
band up and exposed portion of ribbon on side
nearest print wheels, place one spool on spindle
not engaged by lever. Rotate spools to be sure
its pins engage in spindle gear.
5. Thread ribbon around guides and between print
wheels and platen.
6. Install other spool and rotate to engage spindle
gear and also to take up slack in ribbon.
7. Replace printer cover.
Installing Paper Tape
To ensure ease of installation, read the instructions
completely before installing a new paper roll. Then
follow the instructions step-by-step.
1. Tear off excess paper at the tear-off knife.
2. To remove cover, place thumbs on serrated
surfaces located on each side of the cover.
Pressing down with your thumbs, slide the top
cover toward the back of the calculator. Once
the cover has been pushed back approximately
1”, lift the cover off.
3. Lift up and remove old paper roll from the
paper roll holders. Tear off paper between the
used paper roll and the printer. Pull remaining
paper through the printer by continuously lifting
the leading edge (nearest display).
4. With the leading edge of the new paper roll,
feeding from the bottom, place the new roll into
position between the two flexible paper roll
holders.
5. Feed the paper into the rear of the printer
mechanism until it meets resistance
(approximately 1 to 1.5 inches). Depress the
paper advance button until the paper extends
several inches beyond the printer mechanism.
6. Feed the paper through the opening of
the tear-off knife and lay top cover flat on
the calculator leaving a 1” overhang at the
back of the top cover. Apply a firm
downward and forward pressure, slide the
top cover forward until it snaps into
position.
7. Tear off any excess paper.
Spare Supplies
Storage Compartment
(22 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals